ccirn.org

Home > Code 1403 > Error Number 1403 Printhead Problem Canon

Error Number 1403 Printhead Problem Canon

Contents

Kategorie Bildung Lizenz Standard-YouTube-Lizenz Mehr anzeigen Weniger anzeigen Wird geladen... Bring your printer into a Canon repair shop, and they will tell you the bad news. I didn't have to power off, it just worked after reseating the printhead. You can change this preference below.

I used canned compressed air that’s sold at computer stores and it worked pretty well. I have now ordered a new printhead. I can fix most problems with them, but have never been able to overcome the 1 green followed by 5 yellow error code. Did I not clean good enough/or I've an electrical problem??? - unknown Joe I hope you get this; it has been a while since any one has posted on this issue. More about the author

Support Code 1403 Print Head Problem

Customer: replied6 years ago. Hello and welcome to Just Answer. Install correct print head Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎10-26-2013 07:20 PM Hello Neva13,If you've tried the Print something every day for a few days, and try not to go over a week or two without printing something.

Report Inappropriate Content Message 10 of 25 (38,405 Views) Reply 0 Kudos « Previous 1 2 3 Next » « Message Listing « Previous Topic Next Topic » © Canon U.S.A., It has always been my black ink passage that clogs.It’s really not as hard as it may sound. The print head holds all of the other ink cartridges. Canon Mg5520 Print Head D) press the power button.

Each time you clean your print head, it gets a little easier and you get a little faster… I can do a basic cleaning in about 10 minutes if I skip Canon Pixma Support Code 1403 One of the cartridges seemed faulty, so I replaced it with a new one. Each time you clean your print head, it gets a little easier and you get a little faster... http://www.tongfamily.com/2013/10/canon-i9900-1403-print-head-error-and-canon-pro9000-settings/ The print head is what the cartridges sit in inside of the printer.

A compressor at 10-20 psi works better. Canon Mg5520 Error 1403 If the above basic cleaning does not work you may have to get more serious about it. Run hot water over the print head until it runs clear. Choose "Deep Cleaning" and then "Execute." Perform deep cleaning a couple of times if necessary.Step 5Replace the ink cartridge if you continue to get unsatisfactory results for a particular color ink.

Canon Pixma Support Code 1403

Ask Your Own Printers Question Customer: replied6 years ago. http://community.usa.canon.com/t5/Printer-Multifunction-Support/mx922-Not-working-Error-1403-Incorrect-Print-Head/td-p/149396 It still is sitting there giving me the 5 yellow blinks. Support Code 1403 Print Head Problem Not getting Canon again if this is the case Report Inappropriate Content Message 8 of 25 (45,358 Views) Reply 0 Kudos RPMiller New Contributor Posts: 1 Registered: ‎10-29-2014 Re: Error Message Canon Mg5420 Support Code 1403 Showing results for  Search instead for  Do you mean  Register · Sign In · FAQs | Forum Guidelines Canon Community : Canon Forum : Printer : Printer/Multifunction Support : Support Code

Gave it one last try. If it works, print something using a lot of black ink (or the color that was clogged) to run some ink through it. You can do this by holding it under the faucet and using water pressure if you don’t have any other way. Report Inappropriate Content Message 4 of 25 (57,847 Views) Reply 3 Kudos Neva13 New Contributor Posts: 1 Registered: ‎10-26-2013 Re: Error Message is saying "Type of print head in incorrect. Canon Mx922 Support Code 1403

Install correct print head Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎10-26-2013 07:13 PM I have a mp 560 Credentials confirmed by a Fortune 500 verification firm. Me too Report Inappropriate Content Message 1 of 25 (58,549 Views) Everyone's Tags: ernie3786 View All (1) Reply 3 Kudos Jason Moderator Posts: 643 Registered: ‎10-12-2012 Re: Error Message is saying Snap it in, put the tanks back in, and close the lid.

Then try to force some of the solvent through the ink passage using whatever you have... Canon Ip7240 Error Code 1403 I already tried that per the software recommendations and it didn't work. Turn the printer off and then on again.Step 3Run a print test to verify the print quality is acceptable and that the ink is ejecting satisfactorily from the nozzles.

Submitted: 6 years ago.

Open the printers cover, then open Resolved Question: '1403 Print head problem. After I installed new ink cartridges this problem started.Is there anything else I can do? I'll update this post when I find out what is the root cause of the failure. Canon Mg5550 Print Head The mating surface to the print head cartridge is on a flex cable.

What do I need to do?I seen someone else post about this issue and I followed there guidlines but they had a slightly different printer and didnt have the same interior I followed WEBFOOT's responce, but instead of Pressing Resume Twice (B solution), I pressed it THREE (3) times,... Hinzufügen Möchtest du dieses Video später noch einmal ansehen? In your directions on how to clean the printer head you state to sock them in hot water?

Die Bewertungsfunktion ist nach Ausleihen des Videos verfügbar. Place the print head back in and lock the lever down.6. The solvent I first used came with my ink refill kit, I think it was for cleaning up ink. They will first offer 10\% (which sucks), but if you complain about that, they will offer you $299.

Schließen Ja, ich möchte sie behalten Rückgängig machen Schließen Dieses Video ist nicht verfügbar. Place the print head in hot water and let it soak for half an hour or so. Hinzufügen Playlists werden geladen... Leave it a couple of hours in a closed container of solvent if necessary.

I'm thinking it's a hardware problem....but I don't know what to replace. It has always been my black ink passage that clogs. Du kannst diese Einstellung unten ändern. was just about to give up!

it appeared to have a clogged nozzle so i removed the printhead just to take a look underneath... If this message appears again, the print head may be faulty. The type printer that has all the color inks in one cartridge is probably completely different. characters left: Contact Us|Terms of Service|Privacy & Security|About Us|Our Network © 2003-2016 JustAnswer LLC JustAnswer UKJustAnswer GermanyJustAnswer SpanishJustAnswer Japan 125 6657447 Später erinnern Jetzt lesen Datenschutzhinweis für YouTube, ein Google-Unternehmen Navigation überspringen DEHochladenAnmeldenSuchen Wird geladen...

Canon UNHEPFUL and could give a crap by zarkmud on Sep 18, 2008 at 9:19am Add comment Please sign in to comment 0 I cannot agree. Thanks for all those who posted, could'nt have done it without ya'all's.